Cyclonic vacuum cleaners use cyclones – rather than a bag – to capture dirt, dust, and other particles from the vacuum’s airflow..
Only use a damp cloth to clean them..Step 4: Check the Hose and Wand for Clogs.
Remove the wand, then visually inspect it for blockages.. Next, take a look at the hose to see if there are any blockages.If you can remove the hose, then you could also try (gently) pushing the end of a broomstick through to see if there are any clogs deeper in the hose..If you don’t want to remove the hose, then you can visually expand it section by section while looking for darker clogs inside or breaks in the hose..
Step 5: Wash Both the Filters.The Dyson Ball series typically has two washable filters.
It’s important to make sure these are both unclogged, otherwise the amount of air flowing through the vacuum is greatly reduced..
The first filter is located at the top of the cyclones.This tip is simple to perform.
Just run the squeegee over your carpet or other surface to remove hair, but be careful not to press too hard.You might be surprised at how much comes up even after you’ve vacuumed..
Remember to clean your squeegee before using it again on windows or mirrors!.Make Use of Damp Rubber Gloves.
(Editor: Mini Smart Thermometers)